Ericsson EDACS MDX Manual de Instalação Página 1

Consulte online ou descarregue Manual de Instalação para Alarmes para automóveis Ericsson EDACS MDX. Ericsson EDACS MDX Installation manual Manual do Utilizador

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 28
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 0
Printed in U.S.A.
MDX
SERIES
MOBILE RADIO
LBI-38847B
Installation Manual
Mobile Communications
Vista de página 0
1 2 3 4 5 6 ... 27 28

Resumo do Conteúdo

Página 1 - Installation Manual

Printed in U.S.A.MDX SERIESMOBILE RADIOLBI-38847BInstallation ManualMobile Communications

Página 2 - (19D904133, Sh. 3, Rev. 2)

NOTEIn some installations an additional noise suppression filter such as optionPMPD1A (19A148539G1) may be needed for satisfactory performance.NOTEWit

Página 3

NOTEThe relay contact make/break current and voltage rating is 30 amps at 16volts.ALARM (HORN) RELAY KIT - OPTION PMSUIC (19A705499P1)Requires the use

Página 4 - PLANNING THE INSTALLATION

Figure 5 - Mounting Bracket InstallationMICROPHONE HANGERMount the microphone hanger in a location convenient to the operator whereit will not interfe

Página 5

Figure 8- Option Cable Pin LocationsFigure 9 - Bottom View (Cover Removed)16Figure 6 - Microphone HangerNOTEIf mounting on a surface covered with carp

Página 6

Figure 7 - MDX Mobile Radio With MicrophoneMICROPHONEThe microphone connects to the MDX Mobile Radio using a plug found at theend of its attached cabl

Página 7

Figure 7 - MDX Mobile Radio With MicrophoneMICROPHONEThe microphone connects to the MDX Mobile Radio using a plug found at theend of its attached cabl

Página 8

Figure 8- Option Cable Pin LocationsFigure 9 - Bottom View (Cover Removed)16Figure 6 - Microphone HangerNOTEIf mounting on a surface covered with carp

Página 9

Figure 5 - Mounting Bracket InstallationMICROPHONE HANGERMount the microphone hanger in a location convenient to the operator whereit will not interfe

Página 10

NOTEThe relay contact make/break current and voltage rating is 30 amps at 16volts.ALARM (HORN) RELAY KIT - OPTION PMSUIC (19A705499P1)Requires the use

Página 11

NOTEIn some installations an additional noise suppression filter such as optionPMPD1A (19A148539G1) may be needed for satisfactory performance.NOTEWit

Página 12

Copyright© October 1992, Ericsson GE Mobile Communications Inc.TABLE OF CONTENTSINTRODUCTION . . . . . . . . . . . . . . . . . . .

Página 13

Figure 11 - Mounting The External Speaker20Figure 3 - Power Cable4. Push the prepared fuse connectors into each section of the fuse holders. Placethe

Página 14 - MOBILE OPTIONS INSTALLATION

INSTALLATIONRUNNING CABLES To assure the feasibility of the planned cable routings. it is suggested that thecables be run before mounting the radio.

Página 15

NOTES22Figure 2 - Typical Hump Or Dash MountFor passenger safety, mount the radio securely so that the unit will notbreak loose in the event of a coll

Página 16

Be careful to avoid damaging some vital part (fuel tank, transmissionhousing, etc.) of the vehicle when drilling mounting holes. Always checkto see ho

Página 17

(19D904133, Sh. 1, Rev. 3)OPTION INTERCONNECTION DIAGRAM24Interference with Vehicular Electronics - Electronic fuel injection sys-tems, electronic ant

Página 18

Option Description Part NumberPMAN1L 800 MHz roof mount antenna with TNC 19B209568P5connectorPMCC9M External speaker cable, 18 inches 19A149590P8PMCD1

Página 19

(19D904133, Sh. 3, Rev. 2)OPTION INTERCONNECTION DIAGRAM26 INTRODUCTION This manual contains installation instructions for the MDX Mobile Radioseries

Página 20

Copyright© October 1992, Ericsson GE Mobile Communications Inc.TABLE OF CONTENTSINTRODUCTION . . . . . . . . . . . . . . . . . . .

Página 21 - INSTALLATION

Printed in U.S.A.MDX SERIESMOBILE RADIOLBI-38847BInstallation ManualMobile Communications

Página 22

(19D904133, Sh. 3, Rev. 2)OPTION INTERCONNECTION DIAGRAM26 INTRODUCTION This manual contains installation instructions for the MDX Mobile Radioseries

Página 23

Option Description Part NumberPMAN1L 800 MHz roof mount antenna with TNC 19B209568P5connectorPMCC9M External speaker cable, 18 inches 19A149590P8PMCD1

Página 24 - (19D904133, Sh. 1, Rev. 3)

(19D904133, Sh. 1, Rev. 3)OPTION INTERCONNECTION DIAGRAM24Interference with Vehicular Electronics - Electronic fuel injection sys-tems, electronic ant

Página 25

Be careful to avoid damaging some vital part (fuel tank, transmissionhousing, etc.) of the vehicle when drilling mounting holes. Always checkto see ho

Página 26 - INTRODUCTION

NOTES22Figure 2 - Typical Hump Or Dash MountFor passenger safety, mount the radio securely so that the unit will notbreak loose in the event of a coll

Página 27

INSTALLATIONRUNNING CABLES To assure the feasibility of the planned cable routings. it is suggested that thecables be run before mounting the radio.

Página 28

Figure 11 - Mounting The External Speaker20Figure 3 - Power Cable4. Push the prepared fuse connectors into each section of the fuse holders. Placethe

Comentários a estes Manuais

Sem comentários