
Configuration and Management
To disable the DHCP server, clear the Enable DHCP server check box.
Note: If you want to configure your connected devices with static
addresses, make sure that the addresses are outside the DHCP
server IP address range.
To change the range of available addresses, change the IP addresses in
the
IP address range from IP address range to and fields.
Note: - The DHCP server IP address range has to be on the same subnet
as the Ericsson W25 LAN IP address.
- The IP address range must not include the Ericsson W25 IP
address.
- If port forwarding is configured, those settings have to be
removed before changing the DHCP server IP address range. For
information, see section
4.7.3 – “Port Forwarding”.
In the
Lease time [sec] field, enter the time (in seconds) you want the LAN
device to lease the IP address before it is reassigned.
Click Apply to save the settings.
4.5.2 Traffic Statistics
The following information is displayed in the Traffic Statistics section on
the
LAN page:
The total size (and number) of transmitted data
packets on the LAN.
Transmitted
The total size (and number) of received data packets
on the LAN.
Received
Note: The data size and packet counters have the upper limits of 4 GiB
and 2
32
packets (more than 4 billion packets). When these limits
have been reached, the counters wrap around to zero.
4.5.3 Port Status
The Port Status table shows the connection(s) to the LAN (1 - 4) ports on
the Ericsson W25 unit. The status for each port is green (connection) or red
(no connection).
5/1551-CRH 102 167 Uen Rev B 2007-02-01
31
Comentários a estes Manuais