Ericsson 1553-FGC 101 1010 Uen A Guia do Utilizador descarregar pdf (Página 175)

Conditional Access

Figure D.15 EMM Dialog Box [General Tab]

D.7.2.2 EMM Dialog Box: Streams Tab

Table D.8 Adding EMMs (continued)

Step Action Result Comments

7 Click the Streams tab

Enter the ouput PID for the

EMM.

Leave the bit rate set to 30 kbps unless the

customer or CA vendor specifies otherwise

2/1553-FGC 101 1014 Uen B

D-25

1 2 ... 170 171 172 173 174 175 176 177 178 179 180 ... 225 226

Revision History 4
Associated Documents 5
Trademarks 5
Warnings, Cautions and Notes 6
EMC Compliance 6
Contact Information 7
Preliminary Pages 8
1 Introduction 9
Introduction 10
2/1553-FGC 101 1014 Uen B 10
1.1 Terminology 11
1.2 Scope of this Guide 11
MULTIPLEXER 13
KDU XXX XXX/X 13
1.3 Summary of Features 14
Introduction 15
1.3.3 Remote Reflex 17
1.3.4 Conditional Access 19
1.5 Guided Tour 20
1.5.2 Indicators 21
2 Installing and Powering Up 23
Installing and Powering Up 24
Installing and Powering Up 25
2.1 Introduction 27
2.2 Preliminary Checks 28
2.3.3 Lifting 29
2.3.4 Fixing 29
2.3.5 Cable Routing 29
2.3.6 Equipment Access 29
Warnings! 30
Cautions! 30
2.4.1 EN 55022/AS/NZS 3548 31
2.4.2 FCC 31
2.7 Signal Connections 36
MX8400 Multiplexer 37
2.8.1 Overview 39
2.8.2 Static Parameters 41
2.8.3 Reported Faults 43
2.9 ASI IN 1 and 2 44
2.10 ASI OUT 1 to 4 45
2.11 Ethernet CA 1 and 2 46
2.11.2 Static Parameters 47
2.12.1 Overview 49
2.12.2 Static Parameters 50
2.12.3 Reported Faults 50
2.13 RELAY Connector 51
2.15 HSYNC Clock Reference 52
2.15.2 Static Parameters 53
2.15.3 Reported Faults 53
2.17 Powering Up/Down 54
2.17.3 Power up Self Test 55
2.17.4 Start up Sequence 55
2.17.7 Powering Down 56
Chapter 3 57
3.1 What’s Available 59
3.2 ASI Option 60
3.2.2 Connectors 61
(MX8400/HWO/PROFEC) 65
3.3.2 Connectors 67
3.5.1 Overview 73
3.5.2 Static Parameters 75
3.5.3 Alarms 75
3.6 Software Licenses 76
4 Operating the Multiplexer 77
4.1.2 IP Address 79
4.1.3 Netmask 79
4.2 About nCompass Control 80
4.4.1 Definition 81
4.5.1 Introduction 82
Streams 88
4.8.1 Overview 90
4.9.1 Overview 91
4.9.2 Deselect the PSI/SI 92
4.10.2 Mixed PCR System 93
Chapter 5 95
5.1 Introduction 97
5.2 Routine Checks 97
5.3 Servicing 97
5.3.2 Replacement Parts 98
5.4.1 Warranty 98
5.5 Fault-finding 99
Fault Fault Description 100
Warning! 101
Caution! 101
5.6 Overrate Alarms 102
5.7 Missing PIDs 102
A Glossary 107
Glossary 108
Glossary 109
2/1553-FGC 101 1014 Uen B 109
B Technical Specification 127
Technical Specification 128
Item Specification 129
B.2.3 ASI IN 1 – 2 132
B.2.4 ASI OUT 1 – 4 132
B.3 Control and Monitoring 133
B.3.3 RS-232 Remote Control 134
B.4 Reference Signals 135
B.4.3 H SYNC OUT 136
B.4.4 Time Protocol 136
B.5 Service Information 137
B.6 AC Supply 138
B.7 Physical Details 139
B.9 Compliance 140
B.9.3 CE Marking 141
B.9.4 C-Tick Mark 141
B.9.5 Packaging Statement 141
B.9.6 Packaging Markings 142
Technical Specification 143
B.9.8 Equipment Disposal 144
B.9.9 Lithium Batteries 144
B.9.10 Recycling 144
B.10 Cable Types 145
C Static Parameters 147
Static Parameters 148
C.1 Readme First 149
D Conditional Access 151
Conditional Access 152
D.2 Overview 153
D.3 CA Status Monitoring 154
D.4.1 Configure CA Types 155
Conditional Access 157
D.6 ECMG Settings 167
D.6.2 Upload the Map 168
D.8.1 Overview 178
D.8.2 Setting up the Output 178
D.8.3 Connecting the Output 179
D.9.1 Overview 181
D.9.2 Description of SCG ID 181
D.9.4 SCG ID Selection 183
D.9.5 Shared ECMs 183
E Redundancy Modes 185
Redundancy Modes 186
E.1.1 Scope 187
E.1.2 Overview 187
E.2.1 Scope 188
E.2.2 Overview 188
Redundancy Modes 189
E.2.4 Alarms 190
F IP Protocols 191
IP Protocols 192
F.1 IP Protocol Stack 193
F.1.3 RTP Layer 194
F.1.4 UDP Layer 194
F.1.5 IP Layer 194
F.1.6 Ethernet Layer 194
F.2 Stack Download Ports 195
Streaming 197
CoLumns (L) 199
Rows (D) 199
G.3.1 ProMPEG FEC Mode 200
G.4.1 Overview 201
G.4.4 Size of the Matrix 202
Annex H 203
Contents 203
H.1.1 Overview 205
H.3.3 MIP Insertion 209
H.3.4 Static Parameters 210
I PSIG Support 213
PSIG Support 214
I.2 Why do I Need PSIG? 215
I.3 Static Parameters 215
I.3.2 Configuring PSIG 216
I.4 Alarms/Reported Faults 218
J BISS Support 219
BISS Support 220
J.2 Overview 221
J.3 Configuring BISS 222
BISS Support 223

Comentários a estes Manuais

Sem comentários

Ericsson 1553-FGC 101 1010 Uen A Guia do Utilizador Página 175

Comentários a estes Manuais

Manuais e produtos relacionados com Recetor Ericsson 1553-FGC 101 1010 Uen A