Ericsson RX8000 Series Especificações descarregar pdf (Página 35)

Appendix

RX8200 Configuration Guide

xii

Figure 44 RX8200 Alarm Menu

Compatibility Vs Dynamic Mode Alarms

The current dynamic mode alarm functionality utilizes the next available incrementing identifier assigned at start-up.

These identifiers will change depending on the cards present in the unit configuration. The compatibility mode setting

allows pre-defined fixed identifiers to be assigned at startup. This in-turn allows the identifier of different units to be

tracked through the external control system consistently

Input

 No TS Lock – Choose the alarm condition from the drop-down menu to be activated when Transport Stream loses

lock (Set Alarm /No Alarm).

 No TS Lock (relay mapping) – Select the checkbox to activate relay mapping for Transport Stream loss of lock

alarm.

 No Primary Input Lock – Choose the alarm condition from the drop-down menu to be activated when Primary Input

loses lock (Set Alarm /No Alarm).

 No Primary Input Lock (relay mapping) – Select the checkbox to activate relay mapping for Primary Input loss of

lock alarm.

 Monitor Inactive Input – Select the checkbox to activate an alarm when there is no signal present at the Primary

Input .

 No Secondary Input Lock – Choose the alarm condition from the drop-down menu to be activated when Secondary

Input loses lock (Set Alarm /No Alarm).

 No Secondary Input Lock (relay mapping) – Select the checkbox to activate relay mapping for Secondary Input

loss of lock alarm.

 C/N Margin – Choose the alarm condition from the drop-down menu to be activated when the Carrier-to-Noise

margin, set below, is exceeded (Set Alarm /No Alarm).

 C/N Margin (min value) – Enter the Carrier-to-Noise margin minimum value in decibels. This is used to trigger the

alarm condition, set above, when exceeded.

 C/N Margin (relay mapping) – Select the checkbox to activate relay mapping for C/N Margin exceeded alarm.

Output

 IPO Ethernet If 1/2 Down – Choose the alarm condition from the drop-down menu to be activated when there is no

signal at IPO Ethernet 1/2 (Set Alarm /No Alarm).

 IPO Ethernet If 1/2 Down (relay mapping) – Select the checkbox to activate relay mapping for no signal at IPO

Ethernet 1/2.

Service

 Video Not Running – Choose the alarm condition from the drop-down menu to be activated when video is not

running (Set Alarm /No Alarm).

 Video Not Running (relay mapping) – Select the checkbox to activate relay mapping for video not running.

1 2 ... 30 31 32 33 34 35 36 37

Sem comentários

Ericsson RX8000 Series Especificações Página 35