Ericsson 1553-FGC 101 1010 Uen A Guia do Utilizador descarregar pdf (Página 144)

Upgrading EQ8096 with Input and Output Option Cards

5. After the transfer has successfully completed type ‘bye’ to exit the FTP session.

The config.xml file will have been saved to the local directory the FTP was

performed from.

Note: The unit’s IP address and Serial Number. You can obtain the Serial Number

by navigating to the ‘Status’ page on the GUI

Figure 9.7 Status Page

Obtain the Main Control IP address by navigating to the Control port (Main) settings:

Figure 9.8 Control Port Main Screen

9.3.3 Replace the Input Card

To remove and replace the Input Card:

1. Power off the EQ8096 completely.

2. Maintain ESD precautions.

3. Remove the four screws securing the input card and retain for later use.

4. Insert S14483 Card Extraction tools in each of the two M3 bushes below the

securing screw hole.

5. Tighten each tool together this will start to extract the card from the chassis.

6. Before fitting the replacement input card ensure all the EMC tabs are pointing

towards the board surfaces before placing card into the runners on the chassis.

7. Push the card into the unit so the connector locates be careful that the EMC

fingers do not foul on the entrance to the chassis.

8. Refit the four securing screws.

2/1553-FGC 101 1019 Uen A

9-8

1 2 ... 139 140 141 142 143 144 145 146 147 148 149 ... 195 196

Sem comentários

Ericsson 1553-FGC 101 1010 Uen A Guia do Utilizador Página 144