Ericsson RX8000 Series Especificações descarregar pdf (Página 10)

Global Satellite Coverage

RX8200 Configuration Guide

3.4 CONFIGURATION OF NETWORK ACCESS

Access to the RX8200 should be configured on a client site as shown in the Figure 7 below. The management

address of the RX receiver and the second WNE Server IP address should be on the same network as the clients’

local area network (LAN).

WNE Data

172.16.2.x

Management

Client Network

Client LAN 192.168.0.x

.10

Figure 7. Recommended Network Configuration Setup-Example IP Address

If a client network is not available at the time of installation then the configuration of these machines can be setup

as follows. Either using a CTS laptop on the client site or directly to the Dell Server or WNE PC if necessary.

Figure 8. No Client Network Setup

3.5 CONFIGURATION OF RX8200 ON RLS – BROWSER INTERFACE

Access the RX receiver from a browser interface. Depending upon the configuration option chosen above, this

could be done from a browser on the WNE Server or from another PC on the client network. Type the IP address

assigned to the Management interface of the RX unit into an Internet Browser page.

In this example http://192.168.0.2 has been used. Provided that the network is correctly configured, the following

status page will be displayed.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 25 26

Sem comentários

Ericsson RX8000 Series Especificações Página 10