Basic Configuration
34
4/1553-HSC 901 101/2 Uen B 2009-02-27
5 Basic Configuration
Since the nodes get the entire network configuration from the DHCP
Server, the nodes need no configuration. The Management VLAN ID is
stored in flash memory (VLAN ID 246) when dispatched from the factory.
When the nodes are embedded nodes in an EAN, the management VLAN
is configured automatically by the ECN (default VLAN ID 247).
If the node is not an embedded node, the Management VLAN ID can be
changed from the Local Craft Tool (LCT), or by using the Dynamic
Management VLAN concept (please refer to Management VLAN
Configuration Guide or Local Craft Tool User Guide for detailed
information).
Apart from the Management VLAN ID, the EDN312 receives its entire
configuration from a Configuration File located on the Domain File Server.
The ESN108 and EXN104 have their default configuration stored in the
flash memory when dispatched from the factory.
5.1 ESN108 Basic Parameters
Under normal conditions, the ESN108 is managed through PEM. However,
for some tasks the Local Craft Tool is used.
The ESN108 has a set of default data stored in Flash-memory, which can
be changed through the PEM. The factory default settings are:
• Power over Ethernet is enabled on Port 1-7.
• Spanning Tree is disabled.
Note: Spanning tree is enabled through PEM or CLI to an ECN. The
spanning tree default parameter values correspond to the RSTP
standard. The default values can be changed though CLI to the
ECN (embedded) or Node Advanced Configuration (stand-alone).
The spanning tree parameters are stored in the Flash. Once the
spanning tree is set to enable, it will start with spanning tree
enabled again.
The ESN108 has a set of default data stored in Flash that cannot be
changed from PEM. These are the defaults:
• Management VLAN ID (1 to 4095), default = 246.
Comentários a estes Manuais