Ericsson LBI-39001 Manual do Utilizador Página 10

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 96
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 9
LBI-39040 INITIAL SETUP
10
3.3. PI SOFTWARE INSTALLATION
The PI Operating System is ROM resident. The PI application software is installed through a floppy disk interface.
3.4. APPLICATION LOADING
This section describes the installation of the Jessica application from either a floppy disk or a hard drive.
Jessica is supplied with 4 diskettes. The table below discusses loading the first 3 diskettes. Disk 4 deals with the
configuration files which may need to be edited off-line. Review Table 2 before initiating new software installation. Take
care regarding Disk 4, which has CONFIG.DAT, ALLOW.DAT, DISALLOW.DAT, PRIORITY.DAT, IP.DAT,
ROUTES.DAT, PBXFEAT.DAT, and EXPORTS.DAT. For application updates, some of these files may have been tailored
for the customer site. You may wish to skip steps involving Disk 4. If Disk 4 is installed, there is an automatic backup
procedure which copies the old configuration files to the backup directory. You may recover the customer site-specific
information from this backup directory.
Table 1 - Application Loading
Type of Loading Application Expected Results
Application loading from
floppy drive
(Required to install new
Jessica software)
1. Insert Jessica Disk 1 into
the PI.
2. Apply power to the PI or
execute
reboot - h
if
logged into the PI.
3. The PI terminal will
indicate the copy of the
following files to the PI
hard drive:
LOADER.SX
PRI.SX
4. At the prompt for the next
disk, insert Jessica Disk 2
into the PI floppy drive.
5. The PI terminal will
indicate the copy of the
following file to the PI hard
drive:
JESS_A.SX
6. At the prompt for the next
disk, remove Jessica Disk
2 and press "Enter".
7. At the prompt for the next
disk, insert Jessica Disk 3
into the PI floppy drive.
1. The Jessica executable files are copied
to the hard disk.
2. The PRI-48/-64 ISDN board and the
MIC are booted.
3. "Login" is displayed.
Vista de página 9
1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 95 96

Comentários a estes Manuais

Sem comentários