Ericsson LBI-39001 Manual do Utilizador descarregar pdf (Página 9)

INITIAL SETUP LBI-39040

3. INITIAL SETUP

3.1. POWER CORD INSTALLATION

Information for power cord installation for the PI/MUX cabinet is presented below.

110 Volt AC

The North American, Japanese, and Korean T1 PI/MUX power supply feed cord is wired as follows for connection to an

AC power outlet:

Black Hot

White Neutral

Green Earth Ground

220 Volt AC

The European, Asian, and South American E1 PI/MUX power supply feed cord is wired as follows for connection to an

AC power outlet:

Brown Live/Hot

Blue Neutral

Green/Yellow Earth Ground

3.2. PI ADMINISTRATIVE TERMINAL

1. Connect the terminal to the female DB-25 connector labeled "PORT 1/CONSOLE" on the TVME-712M transition

module located in the rear of the PI enclosure. Connect the other end of this cable to the host port or equivalent in

the terminal. If a PC is used as the administrative terminal, then a DB-9 adapter may be needed. In either case, the

serial cable for the terminal is wired straight-through.

2. Configure the terminal for the communications parameters below.

• 9600 Baud

• No Parity

• 8 Data Bits

• 1 Stop Bit

3. If desired, perform the steps below.

• Enter the date command at the PI terminal.

• Type timesav.

4. When the bootup sequence is completed, the following will be the steady-state conditions:

• The red LEDs on all PI boards are not illuminated.

• The amber "STATUS" LED on the PIC board is lit dimly or is flashing.

• The green "RUN" LED on the MIC board is illuminated.

• The green "RUN" LED on the PRI board is illuminated.

• The terminal displays the message "Login."

5. If any of these conditions are not met, then double-check the connections and try to restart the PI by switching off the

power, waiting 15 seconds, and switching on the power again. If normal operation is not achieved, then reinstall the

software.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 95 96

Sem comentários

Ericsson LBI-39001 Manual do Utilizador Página 9