Ericsson LBI-39001 Manual do Utilizador descarregar pdf (Página 13)

INITIAL SETUP LBI-39040

13

Table 2 - CONFIG.DAT File Loading (Cont.)

Type of Loading Application Expected Results

5. At the prompt for the next disk, remove

Jessica Disk 4 and press "Enter".

6. Log in to the system.

7. After the shell prompt is displayed, type

config

to display the configuration

parameters.

8. Verify that the parameters specified on the

floppy disk are displayed with the

config -f

command (displays full configuration).

1. The configuration file is copied

from the floppy drive during the

boot phase.

2. The following Jessica configuration

parameters are displayed when the

config

command is executed:

SITE_ID

HANG_TIME

CONVERSATION_LIMIT

MUX_CHANNELS_MASK

TRUNK_TYPE

Jessica loading of

configuration data

from the hard disk

drive.

1. Engage Jessica system power or execute

reboot -h

if logged into the PI.

2. Log in to the system.

3. After the shell prompt is displayed, type

config

to display a subset of the

configuration parameters.

4. Verify that the parameters specified on the

hard disk are displayed with the

config -f

command.

1. The configuration file is read from

the hard drive during the boot

phase.

2. The following Jessica configuration

parameters are displayed when the

config

command is executed:

SITE_ID

HANG_TIME

CONVERSATION_LIMIT

MUX_CHANNELS_MASK

TRUNK_TYPE

Editing of

configuration

parameters from the

PI terminal or

remotely using Telnet.

1. Configuration parameters may be edited

using the commands below.

•

config -s

sets parameters temporarily. A

reboot erases the settings.

•

savecfg

writes all parameters out to

CONFIG.DAT.

•

config -u

reads in parameters from

CONFIG.DAT.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 95 96

Comentários a estes Manuais

Sem comentários