
LBI-39039
A-2
This appendix presents a copy of Ericsson’s MD110 questionnaire.
TRUNK AND LEAST-COST ROUTING QUESTIONNAIRE
The following information is required for all lines and trunks. The attached form may be used to provide this
information.
ANALOG LINES/TRUNKS
- Which lines/trunks will be through the switch?
- Which of the lines that are to be used in the switch are Incoming only, which are Outgoing only, and which are used
Bothways (INC, OUT, or BWT)?
- Which lines are in a hunting arrangement (CO provided) with each other, and in which order?
- Where should each incoming trunk group and individual trunk terminate (consoles, extensions, hunt groups)?
- Are any of the lines which are to be used through the MD110 Loop Start versus Ground Start? If Loop Start lines
are used, then convert to Ground Start prior to cutover.
(Reminder: Need to have (1) dedicated Loop Start line for the MD110 modem; used for remote diagnostics and
programming. Phone Number: __________________________ )
TIE LINES
- Are there any Tie lines? If so, list the existing access code(s) and the circuit ID(s).
- Should the tie line(s) be used in Least-Cost Routing for the area served by the outbound terminating end? If so, what
calls should be placed over the tie lines? Provide a list of area and local office codes and the outgoing access code
for the far end system(s), if applicable.
- What are the specifications of the tie lines (E&M, Wink Start, 2-Wire, or 4-Wire)?
- Are the lines Analog or Digital?
DIGITAL TRUNKS
- Please list each T1, the circuit ID(s), and how the channels are to be used; Incoming traffic, outgoing traffic, DID,
Flexpath, etc.
- Please indicate which of the following apply:
________ DTMF Signaling
________ Wink Start (for DID over Flexpath (like Tie Lines))
________ Ground Start
________ Common Channel Interchange Signaling (used with PRI)
Comentários a estes Manuais