Ericsson TT1222 Guia do Utilizador descarregar pdf (Página 148)

Front Panel LCD Menus

C.5.21 LS Data Menu

The LS data menu configures the parameters for the output of RS-232 data,

extracted from the transport stream.

Table C.29: LS Data Setup Menu

Menu title: SET:LS DATA Description Section

Mode:

Sets the operation mode of the Asynchronous

data output.

Off - No data is output on the port.

Manual - The data from the PID selected in

the AUX PID menu is output on the port.

Diagnostic - The diagnostic information from

the unit is output on the port.

Default = Off.

----

Aux PID:

Selects the PID that is output on the port if

“Mode” is set to manual.

Default = 0016.

----

Buff Use %:

Shows the fill level of the RS-232 buffer. If this

buffer cycles up to 100% constantly, it is likely

that data is being lost due to buffer overruns.

Note: This is a status item and cannot be set

by the user.

----

Data Port > Enters the Data Port submenu C.5.22

Profile:

Selects the encoding format used by

encoder/transmitter.

Streamed - DVB format.

Piped – Ericsson Proprietary format

Format #2 - Ericsson Proprietary format

TS-Packets - The whole Transport packet

payload

PES Payld - The whole PES packet payload

Default = Streamed.

----

LS Output > Enters the LS Data Output submenu C.5.23

The RS-232 data output cannot exceed the data rate configured in the

communication menu. If the outgoing data rate is higher, information will be dropped

in an unpredictable fashion.

The transmitted PID’s contents should have a lower rate than 115200 bps, since this

is the maximum output rate. If the rate is higher, burst mode can be used, as

explained in Section C.5.23.

EN/LZT 790 0002/2 R1A

C-30

1 2 ... 143 144 145 146 147 148 149 150 151 152 153 ... 197 198

Comentários a estes Manuais

Sem comentários

Ericsson TT1222 Guia do Utilizador Página 148

Comentários a estes Manuais

Manuais e produtos relacionados com Recetor Ericsson TT1222