Ericsson TT1222 Guia do Utilizador descarregar pdf (Página 19)

Introduction

1.3.2.2 nCompass Control / Web Browser (ETHERNET port)

The receiver must have its IP Address and Subnet Mask (in the

Properties:Network menu) configured to conform to the controlling network. The

receiver can then be controlled using web browser or Ericsson nCompass Control

software.

The unit must be set to ‘local’ control to use either of these modes.

1.3.2.3 Remote (RS-232 REMOTE port)

This state is entered when the Ctrl Mode setting (in the Setup:Control menu) is set

to remote. Local mode commands are ignored when the unit is in Remote mode.

1.3.2.4 Director

When Director is enabled (via software license), the TT1222 Receiver can be put

into Director OAC control mode. This is done by selecting Over Air Control (OAC)

for the Ctrl Mode in the Setup: Control menu.

Note: Local mode is the factory default for the Receivers, even when they are

used in a Director system. To switch to Director OAC mode, refer to

Chapter 5, Operating the Equipment remotely.

When in OAC control mode, all Front Panel, Web Browser (and nCompass Control)

and Serial Remote commands are ignored except the operating mode. The TT1222

can be put into a local lockout condition to also ignore the operating mode

command. When in this condition, there are two ways to recover control:

• Cancelling the local lockout using an over-air command.

• Entering a PIN number via the Conditional Access menu on the Front Panel.

Either of these actions will put the Receiver out of local lockout mode.

EN/LZT 790 0002/2 R1A

1-9

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 197 198

Sem comentários

Ericsson TT1222 Guia do Utilizador Página 19