
Front Panel LCD Menus
C.5.30 IP Out Service Config Menu
This menu provides the IP output setup parameters for when Service Filtering is
enabled.
Table C.38: IP SERV CONFIG Setup Menu
Menu title: SET:IP SERV
CONFIG
Description Section
CBR:
Defines the output bit rate when ‘Service
Filtering’ is enabled and CBR mode has been
selected.
Range = 1000-55000 (Units kbps)
Default = 10000 (corresponding to 10 Mbps).
Note: If the incoming service rate exceeds the
CBR rate setting, transport packets may
be dropped.
----
Service ID > Enters the Service ID submenu.
This menu allows the user to select the service
to be filtered.
----
C.5.31 IP Output Menu
This menu provides the setup parameters for the two IP outputs.
Table C.39: IP OUTPUT Setup Menu
Menu title: SET:IP
OUTPUT
Description Section
Port 1 > Enters the setup submenu for IP Out Port 1. C.5.32
Port 2 > Enters the setup submenu for IP Out Port 2. C.5.32
SyncLoss:No Output
Controls the IP output produced when
MPEG II transport stream synchronization is
lost.
No Output – If no valid transport stream is
available, the IP ports will output nothing (i.e.
no packets).
Null Pkts - If no valid transport stream is
available, the IP outputs will output null
packets at a rate of 1 Mbps.
Default = No Output.
----
EN/LZT 790 0002/2
C-35
Comentários a estes Manuais