Ericsson TT1222 Guia do Utilizador Página 42

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 198
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 41
Options
3.2 Hardware Enabled Input Options
3.2.1 Limitations
The TT1222 cannot be fitted with the ASI input option and QPSK input option at the
same time.
3.2.2 ASI Input (TT1222/HWO/ASI/IN)
3.2.2.1 General
The ASI Input card supports ASI transport stream on a single BNC
connector.
3.2.2.2 Connector Details
This is a single 75 Ω BNC connector.
Table 3.3: ASI Input Connector
Input Specification
Connector Type BNC 75 socket
Connector designation ASI IN
Pin: Centre
Shield
Analogue Black and Burst Input
Ground/Chassis
Impedance
Last unit must be terminated with 75 Ω
3.2.2.3 Setting up the ASI Input
There are no set-up requirements for the ASI Input card.
3.2.3 QPSK Input Card (TT1222/HWO/QPSK)
3.2.3.1 General
The QPSK F-type connector is located on the rear of the unit. This input
interfaces directly to Low-Noise Block (LNB) and accepts an
intermediate frequency (IF) input in the 950 – 2150 MHz (L-band) range.
The unit can provide DC power, that may be used for polarization
switching on the LNB, as well as a 22 kHz control signal. The maximum
input symbol rate is 44.5 Msym/s.
EN/LZT 790 0002/2 R1A
3-4
Vista de página 41
1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 197 198

Comentários a estes Manuais

Sem comentários