Contents
Contents
Chapter 1: Introduction
This chapter identifies the equipment versions covered by this manual; describes
the purpose of the equipment in a typical system; provides a summary of its main
features; identifies the controls, indicators and connectors in a guided tour of the
front and rear panels; and lists the available options.
Chapter 2: Installing the Equipment
This chapter provides a guide to the suitability of an installation; gives detailed
procedures for the preparation, installation and configuration of the equipment
including important safety information; provides pin-out details of the external
connectors; and details the power-up/-down procedures.
Chapter 3: Options
This chapter provides a guide to the hardware and software options available that
may be incorporated into unit.
Chapter 4: Operating the Equipment Locally
This chapter provides a guide to using the local user interface; describes the menus,
screens and options available to the user; and details the setting-up, configuration
and operating procedures.
Chapter 5: Operating the Equipment Remotely
This chapter provides a guide to using the remote interface and protocol; describes
the menus, screens and options available to the user; and details the remote
setting-up, configuration, operating and monitoring procedures.
Chapter 6: Alarms/GPOs
This chapter describes the four ways in which the unit may locally monitor the
operational and alarm status.
Chapter 7: Preventive Maintenance and Fault-Finding
This chapter details routine maintenance tasks to be performed; provides general
servicing advice, and information regarding warranty and maintenance; lists the
error messages that may occur, and any appropriate Operator action to be taken;
provides general fault-finding information for other types of problem which may be
encountered; and provides relevant disposal information.
Annex A: Glossary
Annex B: Technical Specification
Annex C: Front Panel LCD Menus
EN/LZT 790 0002/2 R1A 2010-12-17
iii
Comentários a estes Manuais